|
Vintage bikes for sale
Newest Ads first, 13 Ads
|
BMW R60 1968 BMW R60 Awesome conditon, has had a major motor overhaul within the last 500 miles. This include new slinger, piston and rings. good to go another 30k. Bike has been repainted and frames has been powdercoated. 1 small scratch under right cylinder Nothing major. Bike starts 1st kick and idles perfect. Needs a rider Price: 8500 Location: Mystic CT Contact Ben V at Posted Thursday, July 29, 2010 at 11:48:57 (EDT) |
/2 conversion/started a /2 conversion, started but not complete. pics apon request. Price: 2100.00 Location: st. louis Contact bob odell at Telephone 314 346 6893 Posted Tuesday, July 27, 2010 at 07:52:08 (EDT) |
R50/2 basketcase R50/2 frame and matching engine block. also complete R50/2 engine and trans. box of /2 engine parts. 3 /2 fenders, rear swingarm and drive, /5 front forks and wheel. no title, bill of sale. e-mail for photos Price: $2500 Location: Missoula, MT Contact Jim Beyer at Telephone 406-274-3521 Posted Thursday, July 22, 2010 at 20:49:20 (EDT) |
R60/2 sidecar geared bike for sale Selling a matching # 1965 R60/2 with 27/7 rear and 1.44 Speedo. This machine has documentation from BMW Motorrad of St. Louis showing a total rebuild in May of 1980. I bough this machine as a complete sidecar setup from the owner in 2003,drove it for one season then took it off the road for the winter.Not one to take anything for granted, I went through the motor myself. I found the slingers almost clean, all bearings and internals were perfect,I found the carb flanges were warped, no surprise, so I lapped them flat. I put the motor back together with new seals and gaskets intending to use it after the winter, but before that happened I was talked out of (offered too much money) the sidecar, and since I have other solo machines the bike has been sitting in my living room since 2005. This machine has new tapered steering bearings, bar end signals, Halogen headlight conversion, new low sidecar bars & grips, SS risers, 6 gal tank, driver and passenger solo seats.All swing arm and wheel bearings were cleaned, inspected and re lubed.Wheel bearings are properly pre loaded. The tins are a repaint in very nice shape. There are a few spots that need a touch up and I'll do that before the new owner takes possession.The tires are new 3.50 universals so the bike can be ridden solo if desired but still give good sidecar service. The motor runs well starts easily and is a turn key sidecar tug.The front lower sidecar ball is in place so the new owner only has to install the upper eye bolts, attach the tub and go. All Motorrad documents go to new owner. Clear title, actually a transferable registration here in NY. Sold anywhere as long as funds come from a US source no foreign money. Payment in cash in person, Personal Check or Bank Check from a known US bank, both must clear my bank before machine is released, or a USPS money order. Price: $10,500.00 Location: Brooklyn, NY Contact Frank D. at Telephone 917-848-0765 Posted Thursday, July 22, 2010 at 12:09:42 (EDT) |
1969 R50/2 for sale I'm selling a matching # 1969 R50/2. The clock shows 32,900 original miles. The machine has US bars, chrome cylinder guards, original paint and strips in good condition with a few scratches here and there. Small tank with working tool box key. I don't have the key for the steering lock.Tires have plenty of miles left. The motor runs smoothly and starts usually on the first kick. The machine has a small bench seat and a chrome folding Denfeld rear rack. The inside of the tank is rust free with strong red coating. I've been using bike this as my daily rider for two years and other than changing fluids have done nothing to it.I bought this machine from the second owner who owned it for 32 years. It's a good all around machine that you can ride as is. Photos on request.Payment by cash in person, USPS money order, personal check from a known US bank,bank check from a known US bank, both will be held until it clears my bank. I have no problem selling out of the country as long as all funds come from a US source, no foreign money.Shipping is buyers responsibility. Price: $6500.00 Location: Brooklyn, NY Contact Frank D. at Telephone 917-848-0765 Posted Thursday, July 22, 2010 at 11:21:54 (EDT) |
1967 BMW R60/2 Restoration recently completed. This is a matching numbers Sept.1966 R60/2. The engine has been fully rebuilt, new bearings, seals and gaskets through out. The crank was shipped to Cycleworks BMW for inspection (needed no work) new slingers were installed. The pistons are new, 2nd oversize and the cylinder heads were refurbished, guides replaced, valves / seats cut. The clutch assembly is new as well. The wheels have been rebuilt using new German rims, new spokes and the original hubs. Brake drums were turned and new brake shoes installed. The wheels bearings are new and the bearing stacks were shimmed to perfection. New Metzeler "Perfect" tires front and rear. The driveshaft has been rebuilt with a new u-joint installed. Transmission and rear differential (25/8) were inspected and resealed, as they were found to be serviceable. The frame and cycleparts have been powdercoated, the black paint is new as well as the hand striping on the tins. The original Everbest petcock has been rebuilt and the bike still utilizes the original 6 volt magneto ignition. A modern maintenance free 6 volt battery powers the accessory Hella bar end signal lights. Stainless fasteners have been used extensively and all of the rubber pieces are new. I have receipts for the all the new parts. Current mileage is 1,500 kms with no issues. Price: $12,500 Location: Southern Alberta See more at http://b-rod.smugmug.com/For-Sale/For-sale/P1030186/921477822_6nLca-900x900.jpg Contact Chad M at Posted Wednesday, July 21, 2010 at 17:01:53 (EDT) |
1960 R26 i've made this basket case as complete as i can. needs a nut & bolt kit, horn, headlamp shell, and a few minor bits. see craigslist posting for photos. numbers don't match. also available is a matching engine & frame for an R27. i could sell this basket case with those instead, but unfortunately there is no r27 transmission. prefer not to ship. Price: $1800 reasonable offers considered Location: san francisco, california See more at http://sfbay.craigslist.org/sfc/mcy/1850167992.html Contact kenny sweet at Telephone 415-509-0503 Posted Sunday, July 18, 2010 at 23:01:23 (EDT) |
1952 r51 vintage r51, not a stock bike but it runs and is not a basket case.bought it, after 20 years in a garage, replaced coil, filed points started on third kick. carbs leak some gas need a rebuild, needs wiring harness and most electrics. Price: $10500 Location: Ormond Beach, FL Contact Bob Borst at Telephone 3862993987 Posted Saturday, July 17, 2010 at 21:04:20 (EDT) |
1967 R60US for SALE A 1967 BMW R60 US. This bike has been in storage since 1985. Top end removed to determine condition. Compresson was low, but engine was not stuck. Had been converted to battery igition but magneto has been refitted Will need new pistons and bore job. Heads good cores in need of rebuilding. Good sheet metal parts in need of paint. Tank looks good inside. Alloy Weinmann rims in good shape.Carbs appear to be in usable condition. Front seat mounts have been cut off but that is an easy repair. Will need restoration to be pretty but could be a geat rider or future project. Have exhaust headers , mufflers long gone. Price: $4200.00 Location: Anniston, AL 36201 Contact John Swift at Telephone 256-452-3105 Posted Friday, July 16, 2010 at 23:21:48 (EDT) |
R27 1966 Lovely unrestored all original R27. Bar end turn signals albert headlight mirrors bench seat toolkit original manual. 18K miles. Exhaust port repaired and unleaded valve seats by Bob's. Fun daily rider starts on first kick on a good day. Price: $5800 Location: Morris County NJ See more at http://picasaweb.google.com/110372895256585747395/R27# Contact John Martin at Posted Thursday, July 15, 2010 at 13:26:29 (EDT) |
1969 bmw R60 US nice clean tidy rider Rare 1969 BMW motorcycle R60 US for sale, this is a nice clean tidy rider, that runs extremley well, 22000 original miles, all matching number, frames engine and frame plate, frame plate also shows this a is a real R60US and very rare machine these days. everything is clean and shinny with great paint and chrome, the only flaw is the spokes are a bit rusty in places and tires or older, and horn need tweaking to work, otherwise everything works as it should. 6950 obo. call Tim 323 649 9328. bike is in Mount Washington Los Angeles 90065. Price: 6950.00 Location: Los Angeles See more at http://s215.photobucket.com/albums/cc86/greenieltd/bike/ Contact Tim Green at Telephone 323 649 9328 Posted Wednesday, July 14, 2010 at 19:45:25 (EDT) |
1959 R60 1959 R60. Smooth running, MATCHING NUMBERS bike. Corbin seat, Schorch Meier bench seat included. Bar end turn signals. Headlamp mounted mirrors. Resealed trans. New clutch disc. Koni shocks. Good tires. Wixom fairing, saddle bags, no mounts. Aluminum rims. Flanders sidestand. 82K miles. Not a show queen, daily rider. No major dents or dings, just honest wear. Price: 7000.00 Location: Richmond, Va. See more at http://www.flickr.com/photos/21634803@N07/ Contact Steve Hardemon at Posted Monday, July 12, 2010 at 17:22:10 (EDT) |
1957 R26 1957 BMW R26 in very good condition. Original and complete. Easy to crank, not a leaker. $4000 obo. Call Joe, 512-923-3866 Huntsville, Alabama Price: $4000 Location: Huntsville, Alabama Contact Joe Clark at Telephone 512-923-3866 Posted Monday, July 12, 2010 at 14:30:24 (EDT) |
Newest Ads first, 13 Ads
|
|
Return to the IBMWR - BMW Motorcycle Marketplace homepage Copyright © 2007 - IBMWR(tm) - All rights reserved |